Fang Workholding Clamps

 SHIPS IN ONE WEEK 

The Fang Clamp is a stainless steel side-bite hold-down built for jobs where a vacuum isn’t an option. It drives teeth into the edge of your material, locking parts from the side and keeping them put even when the bottom side is uneven or rough. Use them on CNC router spoilboards or fixture plates with 1/4-20 or M6 screws for quick setups.

• Made from Stainless steel in America, for strength and wear resistance
• Side-bite hold down for uneven or "rough" material
  
• Screw to spoilboards or fixture plates
• Use wood screws and washers, 1/4-20, or M6 screws
• Compact design keeps clamp footprint minimal
• Ideal for slab flattening and tricky OP1 workholding
• Works on T-tracks, fixture plates, and spoilboards
• Size: 30mm wide x 76mm long

Optional Hardware Kit

This optional kit has the most useful accessories for the Fang Clamps. Each kit includes enough for a set of 4 Fang Clamps. Thus, 16 Fang Clamps would have 4 Hardware Kits if chosen.

• 6ct - #10 x "Small" Square #2 wood screws
• 6ct - #10 x "Medium" Square #2 wood screws
• 6ct - Neoprene / Aluminum washers
• 8ct - Roller Washers - used for spacing under and or on top of a Fang clamp.
• 2ct - Stop Wedges - used for the "stop side."

In short, the Hardware Kit makes setups easier and faster, and also helps to prevent excessive screw force bending the clamps.

Tip: You can use a screw or "stop" against the dimple at the back end of the clamp to make a more repeatable and steadfast hold.